Our Bolt-On Front Height sensor brackets. For use with Airlift 3H or Accuair management systems. Fits all T1 up to 1965 with ‘Link Pin’ style front axles.
Makes the job of fitting height sensors to the front end of your T1 car as straightforward as possible! Simple bolt on design on to the upper trailing arm just requires the removal and re-fitting of the lower torsion bar grub screw locking nut on both sides.
We recommend fixing the height sensor itself through the shock tower of the beam for best results.
Height sensor mounting points are Drilled and thread-tapped into all of our Air Ride Beams from 2021 onwards - other suppliers beams or older versions of ours will need holes drilling to allow height sensor fitment. See pictures for how best to position them and set up.
4x pre-cut pushrod mounting positions available. Full and accurate height sensing is easily achievable for most air ride setups, with long or short stroke shocks fitted.
2x Sided Height sensor brackets - Raw or Powdercoat finish.
4x M5x50 bolts for pushrod spacing/angle correction
12x M5 plain Nuts
Please consult your Air Management installation guide for correct fitting of height sensors.